Chapter 02. Engineering
Regulation .01 Good Engineering Practice.LinkCopy Citation
The sewerage plant of the utility shall be constructed, installed, maintained, and operated in accordance with accepted good engineering practice to assure, as far as reasonably possible, continuity of service, uniformity in the quality of service furnished, and the safety of persons and property.
Regulation .02 Design and Construction Requirements.LinkCopy Citation
The design and construction of the sewerage plant shall conform to the requirements of the Department of the Environment.
Regulation .03 Minimum Pipe Size.LinkCopy Citation
The mains shall be at least 8 inches inside diameter and the service pipes shall be at least 4 inches inside diameter.
Regulation .04 Adequacy of Sewerage Plant.LinkCopy Citation
The capacity of the utility's plant for the collection, transmission, treatment, and disposal of sewage and sewage effluent shall be sufficiently large to meet all normal demands for service and provide a reasonable reserve for emergencies.
Regulation .05 Inspection of Sewerage Plant.LinkCopy Citation
Each utility shall adopt a program of inspection of its sewerage plant in order to determine the necessity for replacement and repair. The frequency of the various inspections shall be based on the utility's experience and accepted good practice. Each utility shall keep sufficient records to give evidence of compliance with its inspection program.
Regulation .06 Service Pipe Connections.LinkCopy Citation
A.
Utility's Service Pipe. The utility shall install and maintain that portion of the service pipe from the main to the boundary line of the easement, public road, or street, under which the main may be located.
B.
Customer's Service Pipe. The customer shall install and maintain that portion of the service pipe from the end of the utility's portion into the premises served.
C.
Requirements for Customer's Service Pipe. The portion of the service pipe installed and maintained by the customer shall conform to all reasonable regulations of the utility. It shall be constructed of approved materials and shall be installed and maintained in accordance with accepted good practice and in conformance with applicable codes or governmental regulations.
D.
Restrictions on Installation. A sewer service pipe may not be laid in the same trench with water pipe unless the water service pipe is laid on a shelf on the side of the trench, not less than 12 inches above and not less than 18 inches horizontally away from the sewer pipe.
E.
Inspection. If a governmental agency requires an inspection of the customer's plumbing, the utility may not connect the customer's service pipe until it receives a notice from the inspecting agency certifying that the customer's plumbing is satisfactory.
Regulation .07 Main Extensions.LinkCopy Citation
A.
Applications. Applications for extensions of sewer mains shall be made in writing.
B.
Ownership of Extensions. Any facilities installed in connection with the extension of mains shall become the property of the utility.
C.
Construction Specifications. The size, type, quality of materials, and their location shall be specified by the utility and the actual construction shall be done by the utility or by a constructing agency acceptable to it.
D.
Calculating Length of Extension. In arriving at the length of main extension necessary to render service at any point, the distance from that point to the nearest main shall be considered along lines of proper construction, due consideration being given to the general layout of the system. Normally, extensions across streets or roads 70 feet or less in width shall be made at the expense of the utility and may not be considered in arriving at the length or cost of the extension to the applicant. However, in a special situation the applicant may be required to bear a part of the cost of crossing the street or road.
E.
Electing Alternate Route. When the property of the applicant is located adjacent to a street or highway exceeding 70 feet in width, or a freeway, waterway, or railroad right-of-way, the utility may elect to install a main extension on the same side thereof as the property of the applicant, and the estimated cost in this case may be based on such an extension.
F.
Established Grades Required. The utility may not be required to make extensions where grades have not been brought to those established by public authority.
G.
Requirements of Public Authorities. When an extension must comply with an ordinance, regulation, or specification of a public authority, the estimated cost of the extension shall be based upon the facilities required for compliance.
H.
Utility's Portion of Extension. The utility shall extend its sewer mains to serve new customers, other than subdivisions, housing projects, industrial developments, etc., at its own expense, when the cost of the required total length of main extension plus any special pumping facilities required is not in excess of three times the estimated annual revenue to be derived from the extension, which amount shall be designated the “allowance.”
I.
Estimated Annual Revenue. For the purpose of these regulations, the estimated annual revenue for residential service shall be the utility's average annual revenue per residential customer for the prior calendar year, the average to be effective on April 1st and used until the following April 1st. In unusual cases and for other classes of service, the utility may estimate the annual revenue to be derived in each case.
J.
Customer's Portion of Extension. If the estimated cost of the required total length of main extension plus any special pumping facilities required is in excess of the “allowance” for the service connections applied for, the applicant for the service shall be required to advance to the utility before construction is commenced that portion of the estimated cost of the extension over and above the “allowance.” The amount of the advance to the utility may not include any costs of increasing the size or capacity of the utility's existing mains or any other facilities used or necessary in connection with the proposed extension, except as provided in §L, below. If the actual cost of the extension is less than the estimated cost, the utility shall promptly refund to the applicant any overpayment.
K.
Division of Customer's Portion of Extension. When more than one applicant is involved and an advance is required in payment for a main extension in excess of the “allowance”, the amount of the advance shall be divided equally among the applicants, except that some different allocation may be approved by the utility under special conditions.
L.
Extension to Subdivision, Etc. An applicant for a main extension to serve a new subdivision, tract, housing project, or industrial development shall be required to advance to the utility before construction is commenced the estimated reasonable cost of installation of the mains, from the nearest existing main at least equal in size to the main required to serve the development, including necessary service stubs or service pipelines, fittings, pumping stations, etc. If additional facilities are required specifically to provide the service requested, the cost of these facilities may be included in the advance upon approval by the Commission.
M.
Basis For Refunds. For each new customer connected to an extension on which the utility holds refundable deposits, the utility shall refund three times the estimated annual revenue to be derived from the customer. Refunds shall be made within 90 days after the new customer's service is connected and shall be made to the depositors who advanced the money for the extension. If more than one depositor is entitled to receive a refund, the total amount shall be divided in proportion to the amount of the unrefunded advance of each depositor.
N.
Disposition of Advances. Advances which may be required from applicants in payment for extensions will be held by the utility without interest. Refunds shall be made in accordance with these regulations and no depositor will have refunded to him an amount in excess of the amount of his advance. Any amount remaining unrefunded at the end of 10 years from the date the advance was received by the utility shall be retained by the utility and transferred to the Contributions in Aid of Construction account.
Chapter annotations
Authority: Public Utilities Article, §§2-121, 5-101, and 5-303, Annotated Code of Maryland
History: Effective date: September 1, 1965 (Order No. 55971)
History: Regulation .02 amended effective May 14, 2001 (28:9 Md. R. 890)